Iron On Adhesive

£10.00

In Stock

About

We tested all the top adhesives and when none of them lived up to our super-high expectations we went back to the drawing board. After thorough testing we’re super proud to be bringing you a iron on adhesive that’s flexible enough to still sew through (if you want to) and strong enough to stand washing. Simply mark out your design and iron the adhesive to your badge and then get creative attaching it to whatever you like. This super strong and flexible adhesive promises to cut that sewing pile in a jiffy, and the best bit? No one will be able to tell the difference! It’s going to be our worst-kept secret ;) Each pack contains 5 iron on adhesive A4 sheets. Instructions

Remove the paper layer, place your chosen badge on the iron on adhesive and draw around the shape with a ball point pen.
Cut your iron on adhesive to shape using scissors, cutting just inside the line you’ve drawn, making your adhesive slightly smaller than the badge.
Place your backing under your badge and position on your chosen garment or fabric.
Cover with a sheet of greaseproof paper or cotton cloth and iron using the hottest setting your garment/fabric can withstand.
Hold the iron still, applying constant pressure for 30-45 seconds or until all edges are firmly stuck.
Turn the garment inside out or your material over and repeat steps 4 and 5.
Allow the badge to cool down for at least 5 minutes before checking.
If any peeling occurs, re-cover and iron again until the full area is fully adhered.

Do not apply to waterproof, highly elastic, rayon, nylon or tri-acetate fabrics. We would always recommend hand-sewing over ironing however if you choose to sew we would recommend hand washing. If you do choose to machine wash, ensure any garments are inside out before washing or drying and put on a gentle cycle. FOR A FULL INSTRUCTION VIDEO CLICK HERE

Got a sewing pile to rival Everest? We’ve found the solution!

Product Specification